Miniature Wall Sconce



The dollhouse has been rewired using copper tape, and miniature scale outlets.  For most of the lighting I have done so far, this has been sufficient, however, in the hallway I did not want a cord hanging down the wall, and so decided to hardwire the fixture in.  I learned how to solder in order to install the overhead kitchen light,  but did not want to use that method, as it seemed that it would be much more difficult to do on a vertical surface.

Begin by determining the location of your sconce.  Drill a small hole, and run a vertical run of copper tape on the opposite side of the wall, just next to this hole.

Once the copper tape is in place, the next step was to create the sconce itself.  To recreate this you will need:

-a”candle” style bulb with wire attached (found in dollhouse stores)

-two short lengths of aluminum pipe (found in craft or hardware stores, they come in lengths of 2-3′, and varying diameters)

-watch gear or similar object to cap the pipe

-bead cap

To make the sconce, cut the two pieces of aluminum pipe to length.  Near the base of one of the pipes gently drill a hole using a dremel tool.  The trick is to drill the hole without squashing the pipe, as the aluminum is soft.  Line up the horizontal pipe with the hole in the vertical pipe and glue in place.  Next, insert the bulb through the vertical pipe and guide the wire through the horizontal, with plenty extra for wiring.  Glue the watch gear on the base of the vertical pipe to create a finished edge, and insert the horizontal pipe into the beadcap.

Once you know how much wire you need to reach your copper tape, cut to length.  Separate the two wires, and gently strip the insulation.  When stripping the insulation, expose a short length of wire before removing completely, and twist gently to keep the copper strands from separating.  Once the wire is exposed, use two of the brass tacks used installing the copper tape, and wrap each wire around a tack 3 times or so.  Guide the wires/tacks througth the hole in the wall and glue or putty the fixture in place.  The tacks can then be hammered into each run of the copper tape.  This should be sufficient to maintain the circuit.  Make sure not to cross the wires, or allow exposed wire to touch more than one strip.  To keep the wiring in place, adjust as needed and then use electrical tape to secure.

Voila!  You have a functioning wall sconce!




Leave a Reply